Micanan PRO-T - Page 2

2
TABLE OF CONTENTS
PAGE:
VERIFICATION OF OPERATOR AND HARDWARE ___________________________ 3
SPECIFICATIONS ___________________________________________________________ 4
SAFETY INSTRUCTIONS ____________________________________________________ 5
INSTALLATION_____________________________________________________________ 6
ELECTRICAL CONNECTIONS AND SETTINGS________________________________ 10
LIMIT SWITCH ADJUSTMENT _______________________________________________ 24
MICANAN PHOTOBEAM INSTALLATION INSTRUCTIONS_____________________ 25
CLUTCH ADJUSTMENT______________________________________________________ 28
BRAKE ADJUSTMENT_______________________________________________________ 28
EMERGENCY MANUAL OPERATION _________________________________________ 29
OPERATOR MAINTENANCE _________________________________________________ 30
MECHANICAL DRAWINGS AND PARTS LISTS ________________________________ 31
ELECTRICAL DIAGRAMS ___________________________________________________ 33
WARRANTY ________________________________________________________________ 41
OPTIONS
MP00041-44
#40 Drive Chain
MP00023
Double V-belt reduction
MP00045
Cast-iron Pillow block bearings on drive
MP00039
High Cycle modification
PRO-TW/TBW____
Waterproof modification
PRO-T4X/TB4X____
Corrosionproof modification
PRO-TX/TBX____
Explosion proof modification
MP00007 *
115 Volt control circuit
MK00061 **
1.5 sec time delay on reverse
MP00001 **
Timer to Close
PRO-PL____
Separate control panel
MP00024
Trolley hoist Disconnect
MP00030,78-80
Dual Trolley Assembly
MP00035
Minimum Depth modification
* Not available for logic board controls
** Standard feature with logic board controls
WARNING
DO NOT CONNECT TO ELECTRICAL
POWER DURING INSTALLATION
OR SERVICING OF OPERATOR