Micanan PRO-TB - User Manual

INSTALLATION AND INSTRUCTION MANUAL
MODELS: PRO-T, PRO-TB
AUG, 2010

Summary

VERIFICATION OF OPERATOR AND HARDWARE

PRO-T, PRO-TB SPECIFICATIONS

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT INSTALLATION INSTRUCTIONS

PREPARATION

WALL MOUNTING BRACKET AND OPERATOR INSTALLATION

TROLLEY ARM INSTALLATION

ELECTRICAL CONNECTIONS

SECTION A: PRO-T, PRO-TB Standard relay logic controls

CONNECTION OF POWER SUPPLY AND CONTROL STATION

Details power and control station wiring for standard relay logic systems.

SECTION B: PRO-T(M), PRO-TB(M) Relay logic controls with Interface Module

Operator Electrical Connections and Start-up Instructions

Guides on connecting power and starting up operators with interface modules.

SECTION C: PRO-T(E), PRO-TB(E) Full feature logic board Smart 10.0

POWER WIRING INSTRUCTIONS

Instructions for connecting primary power supply to the logic board operator.

ON BOARD O;C;S PBS INSTRUCTIONS

Guidance on using on-board Open, Close, Stop push buttons for operation and troubleshooting.

MOTOR DIRECTION VERIFICATION

Steps to verify and correct motor rotation direction for proper operation.

MODES OF OPERATION

B2: (Momentary on open and close)

Describes the B2 mode of operation for momentary open and close commands.

C2 (Momentary open, constant pressure close)

Details C2 mode: momentary open, constant pressure close with override.

D1: (Constant pressure on open and close)

Explains D1 mode: constant pressure required for both open and close operations.

E2: (Momentary on open, constant pressure on close with roll-back feature)

Covers E2 mode: momentary open, constant pressure close with roll-back.

T: (Momentary on open and close, timer to close, SAFETY ACTIVATION & STOP BUTTON DISABLE TIMER)

Describes T mode: momentary open/close, timer to close, and safety features.

TS: (Momentary on open and close, timer to close secure, STOP BUTTON DISABLES TIMER)

Details TS mode: momentary open/close, timer to close, and stop button function.

PROGRAMMING INSTRUCTIONS

RUN-TIMER SETUP

Instructions for setting the maximum motor run time for open or close commands.

MID-STOP SETUP

TIMER TO CLOSE SETUP

DELAY ON CLOSE SETUP

ON-BOARD RECEIVER PROGRAMMING

INSTALLING THE ANTENNA

PROGRAMMING THE ON-BOARD RADIO RECEIVER

OPERATION

Basic steps for operating the Micanan transmitter.

TO ERASE ALL LEARNED TRANSMITTERS

Procedure to clear all programmed transmitters from the receiver's memory.

DIPSWITCH SETUP

STATUS LED

SECTION D: For all operator control types

LIMIT SWITCH ADJUSTMENT

Guide for adjusting the door travel limit switches for proper operation.

SECTION E: For Operators with Interface Modules or Logic boards

INSTALLATION OF MICANAN N-1 OR N-4 PHOTOCELL

Step-by-step guide for installing Micanan photocell safety devices.

CLUTCH ADJUSTMENT

BRAKE ADJUSTMENT (For model PRO-TB)

EMERGENCY MANUAL OPERATION

OPERATOR MAINTENANCE

WARRANTY

Micanan PRO-TB Specifications

General

Brand	Micanan
Model	PRO-TB
Category	Garage Door Opener
Language	English