Wool Electric Blanket
Instruction Manual
Model MA0275EB-QFW
MA0276EB-KFW
Read in full and retain for future use
Electrical Safety and You
Before using this appliance please read and fully understand the
safety directions in this manual. Ensure that you know how to
operate the appliance. All electrical equipment presents a risk to
the end user. We ask that you use this appliance in a sensible
safe manner in accordance with the instructions supplied for
your own safety. If for any reason the appliance does not
function correctly or shows signs of damage please return it
immediately to the retailer or contact the help line.
Contact enquiry@micasa-appliances.com
Visit www.micasa-appliances.com
Helpline
New Zealand call toll free 0508-274-2722
Australia call +64-9-974-9206
Features
ü New Zealand Wool
ü Fitted design
ü Twin control
ü LED display
ü 9 heat settings with timer
ü 1800mm x 2030mm
ü Electronic overheat protection
Warning! For blankets fitted with a detachable controller
(optional) the blanket must only be used with a controller
marked with the same model number as the blanket.
Operation Guide
Carefully read this manual in full before using this electric
blanket
• Location and Use
Use the blanket as an under blanket only. This blanket is
designed for domestic use only. This blanket is not intended for
medical use in hospitals.
This blanket is designed for domestic use only. This blanket is
not intended for medical use in hospitals.
• Fitting
The Wool Electric Blanket has a deep 45cm wall, fitted with
robust elastic, which helps to keep the blanket securely fixed in
place during the night, plus, this design feature makes it easier
for you to fit and remove from your bed.
Remove any promotional material and all packaging from the
electric blanket.
Ensure the size of the blanket is suitable for the size of the bed.
(A queen blanket should never be used on a king/double/single
bed)
Follow the instructions below for fitting; it is important that you
DO NOT tuck in the wires of the electric blanket.
1. Lay the electric blanket on top of your mattress, so
that the 45cm elastic wall is visible and the controllers
are underneath the blanket, and fed through the fitted
wall at the pillow end of your bed. Ensure the blanket
does not hang over the sides of the bed and the
heating wires are kept clear of the pillow section.
2. Smooth out any folds or creases, and then secure the
fitted elastic wall to each of the four corners and the
sides of the mattress. Pull on the edges of the blanket
to ensure that it sits flat and level on the mattress.
3. Once the electric blanket has been correctly fitted to
your bed, you can make your bed as normal.
NOTE: DO NOT COVER THE CONTROLLER; ALWAYS
ENSURE THAT IT IS UNCOVERED.
• Operation
Dual controls are available for the Queen and King sized electric
blankets. This allows you to control the temperature on each
side of the bed and provide individual comfort.
The blanket can be set to work from 1 to 12 Hours and from
16ºC to 60ºC.
Note! The timer has no 10 or 11 hour setting and operates from
1 to 9 and then 12 (H) setting only.
Plug the supply cord and plug into a suitable power outlet and
switch on.
1. Switch the blanket power on by pressing the ON/OFF
switch to the ON (I) position.
To Next Page
Need help?
General