Why my Michelin Jacks will not lift load?
If your Michelin jack won't lift a load, it might be due to a release valve that isn't completely closed. Make sure the release valve is tightly closed. Another possibility is an overload condition. If this is the case, you'll need to remedy the overload condition.
What to do if Michelin Hydraulic-Jack bleeds off after lift?
If your Michelin jack bleeds off after lifting, it could be that the release valve isn't tightly closed. Ensure the release valve is securely closed. It may also be due to an overload condition; if so, remedy the overload condition. If neither of these resolves the issue, it might indicate a hydraulic unit malfunction, and you should contact Customer Support.
Why Michelin Hydraulic-Jack Jacks will not lift to full extension?
If your Michelin jack isn't lifting to its full extension, the fluid level might be low. Ensure proper fluid level.
What to do if Michelin Hydraulic-Jack Jacks will not lower after unloading?
If your Michelin jack won't lower after unloading, the linkages might be binding. Try cleaning and lubricating the moving parts.
Lists and labels key parts of the hydraulic jack, including handle, lifting arm, saddle, wheels, and castor.
Emphasizes reading and understanding all safety information provided with and on the jack before first use.
Details the jack's design for lifting, not sustaining, loads, and its use with jack stands for vehicle service.
Outlines essential checks including compatibility, familiarization with components, and ensuring smooth operation.
Provides key technical details such as maximum rated load, minimum and maximum height, and operating temperature.
Warns against exceeding capacity, working under supported loads, and specifies use on hard, level surfaces only.
Lists conditions to avoid, including outdoors in rain, severe weather, explosive environments, and with hazardous materials.
Stresses using jack stands, ensuring clear space, and only lifting at specified vehicle jacking points.
Step-by-step instructions for safely lifting a vehicle and then lowering it after removing jack stands.
Covers pre-use checks for damage, oil leaks, corrosion, and recommendations for cleaning and lubrication.
Instructs users to contact local retailers or recycling centers for environmentally safe disposal of the device and oil.
Addresses causes like a closed release valve or overload, and provides corrective actions.
Identifies potential causes such as release valve issues, overload, or hydraulic malfunction with corresponding solutions.
Covers issues like linkages binding, low fluid level, or trapped air, with recommended corrective actions.
To Next Page
General