User’s guide
15
2. Set the Light Switch to “||” for blinking mode.
Switch to Blinker Mode
Attach Hazard Flasher Lens to Light
3. Place the unit in a very visible position or area.
4. Turn the light off when it is not in use.
AM/FM RADIO
The radio can receive frequencies in the standard AM and FM broadcast bands (AM 520–1710 kHz, FM
87.5–108 MHz). An extendable antenna provides adequate signal to receive all local radio stations.
When not in use, the antenna should be stored in the retracted position. This will prevent damage to the
antenna while being transported.
NOTE: All AM band radios are subject to receiving noise interference from electronic devices, static
lightning strikes, and some motorized equipment. If you are operating the inverter and noise is being
received on the AM band, turn off the inverter or change the radio to receive an
FM frequency.
Power &
AM/FM
CH −
Audio Input
Memory
VOL −
To Next Page
Loading...
Need help?
General
