PROBLEM POSSIBLE CAUSE(S) SOLUTION
NOTHING OR ONLY WATER
FLOWING FROM FAUCET
Shuttle is empty
See General Operation to determine how to
properly change a Shuttle
Shuttle tting is not attached
properly
Unscrew Shuttle tting and screw back on
properly
Product Shut Off is in the closed
position
Open Product Shut Off
Air Compressor Shut Off is in the
closed position
Open Air Compressor Shut Off
Water Shut Off is in the closed
position
Open Water Shut Off
LIQUID LEAK
Loose /bad plumbing connec-
tion(s), faulty part(s), loose
faucet(s)
If leak is large and causing ooding, immedi-
ately shut OFF the in-line water valve, power the
unit off, and unplug it from the outlet. Then, call
customer support to report the issue.
If a leak is minor and not an emergency, inspect
the connection on the back of the unit and
assure that the nose cones on the faucets
are tight. If the issue cannot be identied and
resolved in house, call customer support.
GAS LEAK (HISSING SOUND)
Loose connection, severed line, or
faulty part
Power down unit and call customer support
UNIT WON’T POWER ON
Ensure the unit is getting power If it’s not already, plug the unit in
Check breaker panel to ensure
that the circuit breaker is not
“tripped”
Reset the circuit breaker to restore power to the
unit. NOTE: If the breaker trips again after being
reset, review the electrical requirements listed
in the specications above and ensure that the
circuit is capable of handling the load
TROUBLESHOOTING
Do not make adjustments to the unit unless you are authorized to do so. If uncertain, unqualied
or uncomfortable performing any of the steps outlined in the above Solution(s) column of the
troubleshooting guide below, call customer support immediately for assistance.
| 3MICROMATIC.COM SUPPORT (866) 327-4159
To Next Page
Loading...