Micro FLEX - Assembling and Removing Handles

asseMbly InstructIons
27
EN
Assembling and removing the handles / handlebar
MICRO FLEX I FLEX AIR | FLEX 200 | SUSPENSION | BULLET | Monster BULLET | SPRITE | SPEED+ |
ROCKET | WHITE | BLACK | MICRO EAZY
− Assembling the handles: Insert the handles into the T-piece of the steering column. Orient the
handles so that the two locking buons
7
audibly click into the openings provided for this
purpose.
− Removing the handles: Push the locking buons inwards and pull the handles out of the
T-piece of the steering column (see Fig. J).
MICRO LIGHT | SUSPENSION | CRUISER
1. Assembling the handlebar: Loosen the screws
8
with a suitable hexagon socket key and set
the upper part of the fastener
9
aside.
2. Insert and centre the handlebar.
3. Position the upper part of the fastener over the handlebar and tighten the fastener again with
the hexagon socket key (see Fig. K).
CAUTION! The handlebar must be assembled by an adult.