Micro Mini2go Deluxe - Handlebar Adjustments and Attachments; Wear and Tear Procedures; Brake Replacement; Wheel Spring Replacement

wear and tear
27
EN
On the handlebar
1. Attach the silicone band
17
to the bulb
16
(see Fig. V).
2. Make sure that the rubber protection is securely attached to the holders (see Fig. W and X).
3. Wrap the rubber ring diagonally around the rod and attach it to the holder on the bulb (see Fig. Y).
Wear and tear
Changing the brakes
1. Unscrew the eight screws
5
(see Fig. E).
2. Remove the deck
6
(see Fig. F) and unscrew the brake screws with a screwdriver.
3. Replace the brake and screw the deck on again.
Changing the wheel spring
1. Loosen the screw
7
with a screwdriver (see Fig. G).
2. Push the wheel spring
8
upwards and replace it with a new wheel spring (see Fig. H).
3. Put the screw back and tighten it.
Maintenance
Regularly check that all screws are tight, check the condition of the wheels, and replace if necessary. Clean the
Mini2go Deluxe with a soft, moist cloth after each use, and regularly check for visible damage or changes.