Micro SUSPENSION - Adjusting Handlebar Height; Brake System Operation

asseMbly InstructIons
28
Adjusting the height of the extendable rod
1. Open the clamp
12
and push the locking button
10
inwards (see Fig. L).
2. The extendable rod can now be set to the desired height. Pull the extendable rod up or push it
down until a locking button locks into an opening.
3. Then close the clamp again under tension (see Fig. M).
If no locking button is present or you would like a different height for the steering, the height of the
extendable rod can also be customised:
4. Tighten the knurled screw
11
with a hexagon socket key when the clamp is closed. While doing
so, make sure that the extendable rod is securely positioned and does not change height, even
when you put a lot of pressure on it.
If the clamp no longer achieves the desired closing effect, retighten the knurled screw by hand or
with the right hexagon socket key until it is properly closed again.
Brake system
Your MICRO SCOOTER has an innovative brake system. To activate brake, simply step on the rear
wheel brake
13
with either of your feet.
CAUTION, RISK OF BURNING!
The brake fender gets very hot – avoid direct contact with your skin.