• With the exception of Temperature, Communication, Stall, or Electromagnetic Interference codes, most of
the remaining codes can be an indication of a bad connection.
• To verify a proper connection, remove the cable from the Handpiece, and from the Console and inspect the
contacts for the following conditions:
• Moisture
• Signs of Corrosion
• Indications of Damaged or Bent Pins
• Corrosion can impede the electrical signals of your PAL system and may or may not be corrected by
detaching/reattaching the cable. Any visible signs of corrosion should prompt return of the product for
evaluation by MicroAire.
• Any indication of damaged or bent pins should prompt return of the product for evaluation by MicroAire.
Diagnostic Codes
For more information, please reference PAL Electric Console Instructions for Use (IFU) “IM-5025”
LIT-PAL-CS Rev. A 28
To Next Page
Loading...
