Need help?Do you have a question about the MicroAire PAL System and is the answer not in the manual?
Identifies the main components of the PAL System: Console, Handpiece, and Cable.
Details the features and user interface of the 5020 Electric Console.
Describes the PAL-650 Electric Handpiece and its capabilities.
Guides on initial setup, console placement, and cable insertion procedures.
Explains how to identify and address damaged connector pins and contacts.
Outlines manual and automated cleaning steps for the PAL system components.
Details preparation, packaging, and steam sterilization parameters for the system.
Specifies requirements for the gravity-displacement steam sterilization cycle.
Discusses consequences of inadequate cleaning/sterilization, including warranty voidance.
Explains how diagnostic codes are assigned and their general meaning.
Details a specific alert, its cause, and troubleshooting steps.
Guides on inspecting contacts for moisture, corrosion, and damage to resolve issues.
Provides visual examples of good and corroded electrical contacts.
Details common error codes, their definitions, and causes of problems.
Shows location of part and serial numbers on Handpiece, Console, and Cable.
Provides telephone, fax, and email details for customer service.
General| Category | Medical Equipment |
|---|---|
| Cannula Motion | Reciprocating |
| Power Supply | Electric |
| Type | Power Assisted Liposuction System |
| Handpiece Type | single-use |
| Frequency | Up to 400 cycles per minute |
| Features | Ergonomic design |
To Next Page
