If you are using an iPad to program your Edison, follow these steps to test EdBlocks
on your iPad:
1. Open the Edblocks app at edblocksapp.com using one of the following browsers
Chrome, Edge, or Opera.
2. When EdBlocks opens, you will see the programming environment. Click ‘Menu’
and select ‘Load Demos.’ Select the program called ‘Test_Program’ which will
load in the programming environment.
3. Press the ‘Program’ button in the app (top right corner) and the screen flasher
download box appears.
4. Place your Edison V3 over the outline and press Edison V3’s round button one
time, both LEDs will come on.
5. Press ‘download program’ in the download box, and the program will start
downloading to Edison V3.
6. When the program has downloaded to Edison V3 you will hear the ‘success’
sound (the same tune Edison plays when you turn Edison on).
7. Press the triangle button on Edison to run the program.
• EdBlocks programming language app - https://www.edblocksapp.com/
• Getting started with EdBlocks video - https://meetedison.com/robot-programming-
software/edblocks/#edblocksvideo
• Teacher’s guide to EdBlocks lesson activities and student worksheets -
https://meetedison.com/content/EdBlocks-teachers-guide-complete.pdf
• Student worksheet set: 23 lesson activity worksheets -
https://meetedison.com/content/EdBlocks-lesson-activities-complete-set.pdf
• Block guide - https://meetedison.com/content/EdBlocks-block-guide.pdf
To Next Page
Loading...