15
Turn on the saw with the blade
outside of the sled. Wait a few
seconds before advancing the sled
through the cut. There is more
runout when the saw blade initially
starts rotating.
After the blade has cut all the way
through the portion of the ZCI in
front of the fence, pull the sled
back toward the front of the saw
until the blade is again completely
outside of the sled before turning
off the saw.
Install a zero-clearance insert and the desired saw blade.
Make note of the blade used on the ZCI, remove, and hang to store.
Go through each ZCI and blade combination individually using the same method.
STEP 12 - DESIGNATE ZERO-CLEARANCE INSERTS
To Next Page
Loading...