2
Maximum swing over bed 7” diameter
Distance between centers 16”
Spindle taper Morse No. 3 (MT3)
Tailstock taper Morse No. 2 (MT2)
Spindle bore .787” (20 mm)
Cross slide travel 2.559” (65 mm)
Compound slide travel 2.165” (55 mm)
Spindle speed (continuously variable) 0 to 2500 rpm approx.
Thread cutting 12 to 52 TPI in 18 steps
Motor Power 500 Watts
SPECIFICATIONS
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS TOOL.
Operator
COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT.
THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR. PLEASE REMEMBER:
1. When using electric tools, machines or equipment, basic safety precautions should always be followed
to reduce the risk of fire, electric shock, and personal injury.
2. Keep work area clean. Cluttered areas invite injuries.
3. Consider work area conditions. Do not use machines or power tools in damp, wet or poorly lit locations.
Do not expose equipment to rain. Keep work area well lit. Do not use tools in the presence of flammable
gases or liquids.
4. Keep children away from the work area.
5. Guard against electric shock. Prevent bodily contact with grounded surfaces, such as pipes, radiators,
ranges, and refrigerator enclosures.
6. Stay alert. Never operate equipment if you are tired.
7. Do not operate the product if you are under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes might be impaired.
8. Do not wear loose clothing or jewelry, as they can be caught in moving parts. Contain long hair with
a hat or headband.
9. Use eye and ear protection. Always wear:
ANSI approved chemical splash goggles when working with chemicals.
ANSI approved impact safety goggles at other times.
ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists.
A full face shield if you are producing metal or wood filings and/or chips.
10. Keep proper footing and balance at all times.
11. Do not reach over or across running machinery.
12. Always check that adjusting keys and wrenches are removed from the tool or machine before starting it.
13. Do not carry any tool with your finger on the start button.
14. When servicing, use only identical replacement parts.
To Next Page