Rotary Microtome HM 325
MICROM International GmbH
Robert-Bosch-Str. 49
D- 69190 Walldorf 387821 - English
Note:
By experience, usable cuts are only
achieved at a clearance angle of 10° or
more.
• If the clamping lever (fig. 20.3) is loosened,
the upper part of the knife carrier can be
moved 1 cm to the left or right side.
• This way, the cutting edge can optimally be
used.
• The clamping lever for the angle adjustment
can be pulled off after a correct angle setting
to avoid that the angle is "reset" unintendedly.
Moving the knife carrier on the console:
• Loosen the clamping lever (fig. 20.6) on the
left side of the knife carrier, to move the carrier
forwards or backwards on the dovetail guide.
• This allows a rough adjustment of the knife to
the specimen.
Protection against injury:
• A bracket (fig. 20.4) on the clamping plate can
be moved upwards over the blade for the
protection against injury.
To Next Page
Loading...