EasyManua.ls Logo

Micromax Q427+ - SD card not detecting; SD Card Detection Troubleshooting

Micromax Q427+
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Q427+ L3 Service Manual
8. SD card not detecting:
Solution:
Flash the handset with latest SW
Check if the TF card is obviously damaged, if yes, Re-Solder TF connector or change it
Check if the ground impedance of each pin of the TF card socket(except the ground pin)is low(lower than
grade ),if yes, Replace the resistor of the corresponding pin;
Check if the series resistors on each network of the TF card have pseudo soldering ,if yes, Carry out repair
soldering of the series resistors on each signal line;
Check the Power IC normally or not, then Re-Solder Power IC or change it.
Check the CPU normally or not, then Re-Solder CPU or change it.
TF
connector
Power IC
CPU

Other manuals for Micromax Q427+

Related product manuals