Micronta 22-185A - Page 6

Specifications
Continuity Function:
Input Impedance:
Range Selection:
Power Source:
Power Consumption:
Diode Check Function:
Low Battery Indication:
Continuity buzzer sounds at less than 295 ohm (£20 ohm)
input resistance.
Buzzer sounds 100 ms — 150 ms (typical) after input is |
shorted.
For checking semiconductors open, short or normal.
10 Megohm (DCV/ACV).
More than 100 Megohm on 300 mV DC
Manual range
Four “AA” size 1.5V batteries, providing +3V
10 mW typical
“BATT” on the left of display indicates when + or —
supply is below 2.4V —2.6V.