Copyright © 2015, All Rights Reserved.
NOTE:
Always make sure the total length of the TX cable DOES NOT exceed 100 meter. Total length
is defined as length A + length B.
PD
Remote Switch
A
B
Length A + Length B < 100 meter
Maximum total cable length is 100 meter.
During 1000 Mbps speed transmission, recommend maximum cable length less than 90
meter is recommended.
POE signal attenuates every meter, the built-in transformer allows the attenuation to reach
100 meter long to follow IEEE802.3af / at standard. The higher quality of PD you connected
to, the more reliable the network will be. When connect to a poor quality PD, it cannot
generate strong signal to send to remote switch. Always make sure you have a high quality
PD to perform a desired network.
To Next Page
Loading...