Microsoft VNX-00003 Kickstand Replacement Guide

12 M1192218
3. Remove hinge screws – Using the 3IP (Torx-Plus) driver, loosen all four hinge screws by 2-3 rotations. With
the screws loose, use your nger to hold the back of the kickstand behind each hinge while fully removing the
two hinge screws. Ensure screws do not fall into the hinge opening.
4. Lay Kickstand Down – Lay the kickstand at against the IBC. Be careful not to jostle the kickstand in this
position as it may cause abrasions on the IBC.
HOLD

Microsoft VNX-00003 Specifications

General

Brand	Microsoft
Model	VNX-00003
Category	Tablet
Language	English