III
98-05018
R2
TASC 6100
CE & STANDARD V ERSION
TABLE OF CONTENTS
CHANGE LOG II
TABLE OF CONTENTS III
LIST OF ILLUSTRATIONS V
HOW TO USE THIS MANUAL VI
CHAPTER 1 SWITCHES AND CONTROLS 1-1
CONSOLE SWITCHES AND I NDICATORS 1-1
POWER SWITCH 1-1
MODE SELECTOR SWITCH 1-1
INC / DEC SWITCH 1-2
BOOM SECTION “ON/OFF” INDICATORS 1-2
RATE SWITCH 1-2
DISPLAY SELECTOR SWITCH 1-2
IMPLEMENT STAT U S INPUT 1-6
GROUND SPEED OVERRIDE SWITCH (GSO) 1-7
CHAPTER 2 CALIBRATION 2-1
SELECTING THE A PPLICATION PROGRAM 2-1
SELECTING ENGLISH OR METRIC, UNITS 2-1
UNITS FOR EACH DISPLAY SELECTOR SWITCH POSITION 2-2
UNITS FOR EACH DISPLAY SELECTOR SWITCH POSITION 2-2
CHANGING UNITS 2-2
LIQUID/GRANULAR COMMON SETUP ITEMS 2-3
SETTING A PPLICATION RATES 2-3
SETTING THE % RATE CHANGE 2-3
SETTING BOOM WIDTHS 2-4
DISTANCE CALIBRATION - GROUND SPEED SENSOR 2-5
SETTING THE HOLD/CLOSE RESPONSE OF THE FLOW CONTROL VALVE 2-7
SETTING THE GROUND SPEED OVERRIDE (GSO) VALUE 2-9
PRODUCT V OLUME (FULL LOAD V ALUE) 2-10
RESETTING A CCUMULATORS 2-11
OPERATING UNDER EXTERNAL RATE COMMANDS 2-11
LIQUID ONLY SET-UP 2-12
SETTING THE CORRECTION FACTOR 2-12
FLOW SENSOR CALIBRATION 2-12
GRANULAR ONLY SET-UP 2-20
SETTING THE PRODUCT DENSITY 2-20
SETTING THE FAN TACH CAL. # 2-20
RATE SENSOR CALIBRATION 2-21
SETTING A UTO POWER DOWN TIME 2-24
CHAPTER 3 OPERATION 3-1
NORMAL STA RT-UP AND OPERATION 3-1
CHANGING A CTIVE BOOM SECTIONS 3-2
CHANGING A PPLICATION RAT E 3-2
ALTERNATE A PPLICATION RATE 3-2
% RAT E CHANGE 3-2
PRIMING THE MAIN PUMP AND BOOM 3-3
RAPID UNLOAD USING THE CONVEYOR 3-4
GROUND SPEED OVERRIDE (GSO) 3-5
To Next Page
Loading...