Mid-tech TASC-6100 - Page 59

5-7
98-05018
R2
TASC 6100
Erro
rs
CE & STANDARD V ERSION
Consult Operator's
Manual for the correct
switch sequence.
Hold down the decrease
switch until the alarm
stops. Check to see
which constants have
been set to zero and re-
enter the correct values.
Hold down the decrease
switch until the display
re-sets to zero.
Establish good ground
and battery connections.
This is the most common
fault when system is
acting erratically.
Check and service or
replace the vehicle
battery.
Check and service or
replace the vehicle
alternator/voltage
regulator.
Err
Err E
OFLO
Err L
Incorrect switch se-
quence is selected on the
console.
Memory error.
This is often the result of
a poor battery connec-
tion.
Value to be displayed
exceeds the maximum
allowable size.
The vehicle electrical
system voltage has fallen
below about 10.0 VDC.