I-00470 Rev -
RackLink
In-Line Models
MOUNTING INSTRUCTIONS
1) Loosen the thumb-screw until it becomes disengaged from the RackLink
unit (1). DO NOT fully remove the thumb-screw. The retainer washer
will hold the thumb-screw in place. Remove the RackLink
unit from the mounting bracket (2). (FIGURE A)
2) Install a screw into an oval nut as shown. Once tightened, insert the
oval nut into the slot in the rackrail bracket. Slide into the desired
location. (FIGURE B)
INSTALLATION
RACKRAIL
SLOT
™
PARTS LIST CALLOUTS
PARTS LIST QTY
A - RackLink Unit 1
B - Mounting Bracket with Factory Installed Thumb-Screw
and Integrated Retainer Washer
C - Oval Nut 2
D - #3 Phillips Head Screw 2
(FIGURE A)
(FIGURE B)
1
2
1
A B C
D
To Next Page
