14
Snap the brush top end on the upper edge of iron head, and fasten the brush when the
iron head is aligned with the boss of brush lower edge.
Dismantle in reverse after use.
Installation Of Brush
Safety Protection
1. Temperature detection protection: The Garment Steamer is equipped with a built-in
temperature sensing element. When there is abnormal temperature, the temperature
sensing element will emit signals to control the connection and disconnection of the
heating element, thus keeping the product temperature within a suitable range.
2. Thermal fuse protection: The garment steamer is provided with a thermal fuse. When
a temperature is abnormal and the thermostat fails, it switches off directly to avoid
any accident.
3. Dry Boil protection: Water insufficiency alert and automatically cut power if boil dry.
When the pump is boiling without water, the alarm buzzer will work immediately.
Meanwhile, power will be cut off after the indicator blinks three times to protect the
garment care.
Installed
dismantled
dismantled
Installed
Installation Of Seam Clamp
Snap the clamp top end on the upper edge of iron head, with lower boss snapped
below.
Dismantle in reverse after use.
To Next Page
Loading...