13
INSTALLATION INSTRUCTIONS
SECURE THE ACCORDION PANELS
4
B. Slide the free end "Ⅰ" section of the panel directly
into the cabinet as shown in Fig. 2. Slide the panel
down. Be sure to leave enough space to slip the
top and bottom of the frame into the rails on the
cabinet.
Fig.2
"Ⅰ"section
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments.
Slide the top and bottom ends of the frame into the
top and bottom rails of the cabinet. Fig.3.
D. Slide the panel all the way in and repeat on the
other side.
Top Rail
Bottom Rail
Fig.3
A.Keep a firm grip on the air conditioner, carefully
place the unit into the window opening so the bottom
of the air conditioner frame is against the window
sill (Fig.5A and Fig.5B). Carefully close the window
behind the top rail of the unit.
Fig.5A
NOTE: If storm window blocks AC, see Fig. 11.
Top Rail
Bottom Rail
Top left
Top right
Fig.4
Wooden Windows
INSIDE
OUTSIDE
H:About 3/4 to 1 （for 5 to 8K);
Measure from the cabinet edge
3
H:About 1 to 1 / （for 10 to12K);
8
H
Fig.5B
Vinyl-Clad Windows
INSIDE
OUTSIDE
H:About 3/4 to 1 （for 5 to 8K);
Measure from the cabinet edge
3
H:About 1 to 1 / （for 10 to12K);
8
H
NOTE: Check that air conditioner is tilted back about
O O
H (Fig.5A and Fig.5B) (tilted about 3 t o 4 downward t o
th e o utside).
After proper installation, condensate should not drain
from the overflow drain h ole d uring n ormal u se, c orrect
the slope otherwise.
B.Extend the side panels out against the window
frame (Fig.6).
window
frame
Fig.6
INSTALL SUPPORT BRACKET
5
A.Place the frame lock between the frame
extensions and the window sill as shown(Fig.7A for
Wooden windows), (Fig.7B for Vinyl-Clad windows) .
"
To Next Page
Loading...
