AIR CONDITIONER FEATURES
CAUTION
Please always wait 3 minutes when turning unit off
then on again, and when changing from cool to fan
and back to cool. This prevents compressor from
overheating & possible circuit breaker tripping.
WARNING
!
To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY
INSTRUCTIONS before operating this appliance.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or
cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable air flow (see Air
Directional Louvers).
4. Once the room has cooled, adjust the thermostat to the
setting you find most comfortable.
5. Make sure that the air flow inside and outside are not
obstructed by anything.
Air Directional Louvers
Lever
Air Direction
The louvers will allow you to direct the air flow Left or
Right throughout the room as needed.
Move the Levers from side to side until the desired
Left/Right direction is obtained.
for 05K, 06K
The louvers will allow you to direct the air flow Up or Down(on some models) and Left or Right throughout
the room as needed. Pivot horizontal louvers until the desired Up/Down direction is obtained.
Move the Lever(s) from side to side until the desired Left/Right direction is obtained.
Do not damage or use an unspecified power
cord.
Fresh Air Vent Control
K models):
Fig. A (VENT CLOSED) Fig. B (VENT OPEN)
Fig. C (VENT & EXHAUST
OPEN)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig.A)
2. Draw fresh air into the room- Vent Open (see Fig.B)
3. Exchange air from the room and draws fresh air into the room - Vent and Exhaust Open (see Fig.C)
Levers
Air Direction
Levers
Air Direction
Air Direction(4- way)
Levers
17
for 06K, 08K, 10K, 12K, 14.5K
(on 10~14.5
To Next Page
Loading...
