To Next Page

To Previous Page

OPERATION MANUAL KJR-29B/BKE-E

(5)Temperature setting

Under AUTO, COOL, DRY, HEAT modes, press the Temp adjust Up/Down buttons to set the

temperature, the adjusting range is 17℃~30℃ (or 62℉~88℉). The setting temperature cannot be

adjusted under FAN mode.

(6)Timer on and Timer off setting

Press the timer/clock setting button, then enter into the timer on setting status, and the screen will

display timer icon and .

You can press Temperature setting buttons to adjust the time. When the time setting is less than

10 hours, each press the Temp setting buttons will increase or decrease 0.5 hour. When the timer

setting is more than 10 hours, each press Temp setting buttons will increase or decrease 1 hour,

the maximum timer setting is 24 hours. After finish adjusting the time on setting, press the

26℃/OK button or wait for 5 seconds to confirm and exit the time on setting.

Notes: If the wired remote controller has been set timer on/ off, press the ON/OFF button to turn on/ turn off the

unit then the timer will be canceled simultaneously.

(7) Clock setting

Long press the timer/clock setting button for 3 seconds, and then enter into the clock setting

status. The hour position of the clock will flash, and can press Temp setting buttons to adjust the

hour value.

After finish the hour setting, press left button or right button to switch to minute position setting,

then the minute position will flash, press Temp setting buttons to adjust the minute value. After

finish the clock setting, press the button or wait for 5seconds to confirm and exit the setting state.

(8)Quiet/OK button

Under the cooling, heating and auto mode, when operate the quiet mode, it can reduce the

running noise through setting the fan speed to low. This will help you bring a quieter environment.

Under AUTO, DRY mode, the fan speed is auto and the Quiet /OK button doesn’t work.

(9) Wired controller locking

Press the temperature adjusting UP and DOWN buttons simultaneously, the wired controller

enters into locking state, and the locking icon will be lighted up. Under the locking state, the wired

controller will not respond to buttons by pressing and the control instruction from the wireless

remote controller. Simultaneously press temperature adjusting buttons again will cancel the

locking state.

Midea KJR-29B User Manual

Questions and Answers: