Side Brushes Installation
Smart Vacuum Robot Charging
With unit upside down, align side brush
over brush holder. Please keep the color
of the side brushes the same as each
brush racks.
Press the side brush until it snaps in place.
Put the docking station in place.
Place it against the wall and
remove all the obstacles in the
surrounding as shown in below
figure. Please do not place the
docking station on the carpet
and ensure that the surrounding
is clean and dry. Please be
reminded to remove the
mopping holder when charging
is in progress.
Place the vacuum robot on the
docking station and ensure that they
are properly connected. A white
light will start flashing to indicate
that the vacuum robot is charging.
If there is suspended condition in the cleaning are, please fix or block it to
avoid potential injuries.
follow the vacuum robot to identify if there is any potential problems
during the first cleaning. If there is any area that do not need to be cleaned
or the robot may get trapped, you can add a restricted area or virtual wall
on the map of the APP to prevent if from entering the restricted district.
stagnant
Charge for 12 hours before first time usage
To eectively extend the battery life span, you should:
Recharge the device as soon as possible when the battery power is low.
If you do not use the device for a long period of time, fully charge the battery and store
it at a ventilated and dry place.
To Next Page
Loading...
