Why Midea MAW05R1JWT-B does not start?
Your Midea air conditioner might not start due to several reasons: the wall plug may be disconnected (push it firmly into the outlet), the circuit breaker may be tripped (reset it), the power may be off (turn it on), or the unit was recently turned off and on (wait 3 minutes before restarting). Also, check if the light on the plug is on. If it is off, press the RESET button.
Why Midea MAW05R1JWT-B Air Conditioner turns on and off rapidly?
Your Midea air conditioner might be turning on and off rapidly due to a dirty air filter restricting airflow (clean the air filter) or the outside temperature being extremely hot (set the fan speed to a higher setting). Also, check for and clear any obstructions blocking the outdoor intake/exhaust.
What to do if Midea MAW05R1JWT-B Air Conditioner is cooling, but room is too warm and NO ice forming on cooling coil behind air filter?
If your Midea air conditioner is cooling but the room remains too warm without ice forming on the cooling coil, consider these possibilities: the air filter might be dirty or restricted (clean the filter), the temperature might be set too high (lower the temperature), air directional louvers might be improperly positioned (adjust them for better air distribution), the front of the unit might be blocked (clear any obstructions), doors or windows might be open (close them), or the room may require more time to cool down due to 'stored heat'.
What to do if Midea MAW05R1JWT-B Air Conditioner is cooling, but room is too warm and ice forming on cooling coil behind air filter?
If your Midea air conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, it might be due to the outdoor temperature being below 64°F (18°C), a dirty air filter, or the thermostat being set too cold for night-time cooling. To defrost the coil, set the unit to FAN ONLY mode. Clean the filter. If the thermostat is too cold, set the temperature to a higher setting.
Why Midea MAW05R1JWT-B Air Conditioner air from unit does not feel cold enough?
If the air from your Midea air conditioner doesn't feel cold enough, it could be because the room temperature is below 62°F (17°C) (cooling may not occur until the room warms up), the temperature sensor behind the air filter is touching the cold coil (try to move it), or the compressor shut-off by changing modes (wait approximately 3 minutes and listen for compressor to restart when set in the COOL mode). Also, try resetting to a lower temperature and check for any obstructions blocking the outdoor intake/exhaust, and clear them.
Why Midea MAW05R1JWT-B Air Conditioner makes noise when unit is cooling?
The noise you hear when your Midea air conditioner is cooling could be due to normal air movement sounds (if too loud, set to a slower fan setting) or window vibration from poor installation (refer to the installation instructions or check with the installer).
Why Midea Air Conditioner is dripping water OUTSIDE when unit is cooling?
If your Midea air conditioner is dripping water outside while cooling, it is likely due to the unit removing a large quantity of moisture from a humid room. This is normal during excessively humid days.
What to do if Midea MAW05R1JWT-B Air Conditioner is dripping water INSIDE when unit is cooling?
If your Midea air conditioner is dripping water inside when cooling, it's likely due to improper installation. Tilt the air conditioner slightly to the outside to allow for water drainage. Refer to the installation instructions or check with the installer.
Why Midea Air Conditioner room is too cold?
If your Midea Air Conditioner is making the room too cold, the temperature setting is likely too low. Increase the temperature setting.
Why Midea MAW05R1JWT-B remote sensing deactivating prematurely?
If the remote sensing on your Midea air conditioner is deactivating prematurely, ensure the remote control is within 16.4 feet and 180° radius of the front of the unit, pointed towards it, and that there are no obstructions blocking the signal.
Guide on placing the AC unit into the window and securing it with frame locks.
Recommended operating temperatures and how to start and control the unit.
Guidelines for using the remote control and its technical details.
Instructions for setting the timer to automatically turn the unit ON.
Steps for acquiring and accessing the SmartHome mobile application.
Procedures for the app to find and add the air conditioner device.
Overview of the app's user interface for managing AC functions remotely.
Instructions for cleaning the air filter and the unit's exterior cabinet.
Solutions for problems related to the unit not starting or insufficient cooling.
Addresses issues like ice buildup on coils and room temperature concerns.
Outlines the warranty period, what Midea covers, and consumer duties.
Lists items not covered by warranty and steps to obtain service.
General| Type | Window |
|---|---|
| Cooling Capacity | 5, 000 BTU |
| Energy Efficiency Ratio (EER) | 11.0 |
| Voltage | 115V |
| Amperage | 4.8 A |
| Noise Level | 52 dB |
| Room Size | 150 sq. ft. |
| Operating Frequency | 60 Hz |
| Cooling Amps | 4.8 A |
| Air Flow (High) | 147 CFM |
| Window Opening Range (Min-Max) | 23-36 inches |
| Refrigerant | R32 |
To Next Page
