7. SWING Button
Used to initiate the Auto swing feature. When the
operation is ON, pressing the SWING button can
stop the louver at the desired angle.
Wireless operation (on some models):
• For the fi rst time to use Wifi function, press the
SWING button for 3 seconds to initiate the Wifi
connection mode. The LED DISPLAY shows
‘AP’ to indicate you can set Wifi connection.
If connection (router) is successful within
8 minutes, the unit will exit Wifi connection
mode automatically and the Wireless indicator
illuminates. If connection is failure within
8 minutes, the unit exits Wifi connection
mode automatically. After Wifi connection is
successful, you can press and hold POWER
and DOWN ( ) buttons at the same time for
3 seconds to turn off Wifi function and the
LED DISPLAY shows ‘OF’ for 3 seconds, press
POWER and UP (
) buttons at the same time
to turn on Wifi function and the LED DISPLAY
shows ‘On’ for 3 seconds.
FRESH operation (on some models):
• Press SWING and TIMER buttons at the same
time for 3 seconds to initiate FRESH feature and
the FRESH light illumiantes on some models, the
LED DISPLAY shows ‘On’ for 3 seconds. The ion
generator is energized and will help to purify the
air inside. Press it for 3 seconds again to stop the
FRESH feature and the FRESH light turn dark on
some models, the LED DISPLAY shows ‘OF’ for 3
seconds for some units.
Displays
LED Display:
Shows the set temperature in “°C” or “°F” and the
Auto-timer settings. While on Fan Only mode, it shows
the room temperature. If the room temperature is too
high or low, it will display “HI” or “LO”.
The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the UP (
) or
DOWN (
) buttons at the same time for 3 seconds.
Error codes:
The unit may stop operation due to a malfunction
with the unit. If this occurs, an error code may appear
on the display like below.
Wait 10 minutes as the problem may resolve itself.
If not, disconnect the power, then connect it again.
Turn the unit on.
If the problem persists, disconnect the power and
contact customer service.
Error code appears and begins with the letters as the
following in the window display of indoor unit:
EH(xx), EL(xx), EC(xx) , PH(xx), PL(xx), PC(xx).
If the unit turns off unexpectedly due to the power
being cut, it will automatically restart with the
previous function setting when the power resumes.
NOTE
Air Directional Louvers
The louvers will allow you to direct the air fl ow up or
down (on some models) and left or right throughout
the room as needed. Use the SWING button until the
desired up/down direction is obtained.
Move the louvers from side to side until the desired
left/right direction is obtained.
Use SWING button for up/down direction
Adjust louvers for left/right direction
Air Direction
LED
Display
To Next Page
Loading...
