05
EN
Start to use
• After transportation, please let the cooler stay for more than 2 hours before
turning on the power, otherwise it will lead to a decrease in cooling capacity
or a damage to the cooler. The cooler shall stay for half an hour before
connecting power when it is rstly started. Clean up the inner chamber before
put into use for rst time .
• Please pull out plug in case of power failure or cleaning. Do not connect
the cooler to power supply within ve minutes to prevent damages to the
compressor due to successive starts.
• In the process of compressor work, water droplets or frost will be formed on
the back wall of the refrigerated compartment, which is a normal phenomenon.
After a period of time, the frost will melt into water and ow into the water
tray to evaporate away.
• Do not connect cooler to electronic energy saving plug and converter that can
convert DC into AC (e.g.: solar energy system, ship grid).
Recommended layout for beverage can in the cabinet
• Do not let bottle touch the back side of cooler in order to maintain good air
circulation in the cooler.
• The capacity for bottle storage in the wine cabinet (MDRW111FGG shown
as Fig.2, MDRW150FGG shown as Fig.3 ) is based on the following marked
bottle size (Fig.1) . Oversized bottle may have impact on the number of bottle
storage in the wine cabinet.
• For model MDRW111FGG: The recommended maximum bottling volume is 24
bottles, as Fig.2
• For model MDRW150FGG: The recommended maximum bottling volume is 34
bottles, as Fig.3
The picture above is only for reference. The actual conguration will depend on the physical
product or statement by the distributor.
Fig.2
Fig.3
Fig.1
215mm
300.5mm
27.5mm
76.1mm
ATTENTION
To Next Page
Loading...