DELAY and
EXTRA
RINSE
Control Lock/Hold 3 sec
You can lock the
controls to prevent any
selections from being
made. Or you can lock
or unlock the controls
after you have started
a cycle.
Children cannot
accidentally start the
washer by touching
buttons with this
option selected.
To lock the washer, press
and hold the Delay and
Extra Rinse buttons for
3 seconds.
To unlock the washer
controls, press and hold
Delay and Extra Rinse
buttons for 3 seconds.
NOTE: The Power button
can still be used when the
machine is locked.
START/PAUSE
Press to start a wash
cycle. If the washer
is running,pressing it
once will pause the
washer. Press again to
restart the wash cycle.
If you want add a
garment, please press
the
button.
The washer will unlock
the door. Press again
to restart the cycle.
NOTE: In some cycles the
washer will drain first,then
unlock the door when it is
paused.
NOTE: The washer performs
automatic system checks
after pressing the button
You may hear the door lock
and unlock before water
flows, this is normal.
Display
Displays the
approximate time
remaining until the end
of the cycle.
NOTE: The cycle time
is affected by the
water pressure in your
home and the balance
of the load in the
washer. You may see
the time remaining on
the display increase to
accommodate a slower
spin speed to handle
unbalanced loads.
Wash
Rinse
Spin
Cycle status is also
displayed and certain
features such as Delay
Wash or Steam are shown
indicating they have been
selected.
A
Display
Wash Time Delay Time
END Error
B
Remain-Delay
C
Child Lock
D
Door Lock
Washer
Safety
Operation
Requirements
Installation
Instructions
Troubleshooting Washer CareWasher Use
18
To Next Page
Loading...
