Why is my Midea Washer not draining or spinning?
If your Midea Washer isn't draining or spinning, check the fuse or reset the circuit breaker. Also, ensure the lid is closed and press the Start/Pause button. Finally, make sure the drain hose is not kinked.
How to fix excessive vibration or noise in Midea MLV43A3AWW?
Excessive vibration or noise in your Midea Washer can occur if the appliance isn't on a level surface or is touching another object. Ensure the laundry load is balanced and check for any packaging pieces stuck underneath the washer.
How to stop water leaks from Midea MLV43A3AWW Washer?
If your Midea Washer is leaking water, ensure that all hose connections are tight. Also, make sure the end of the drain hose is correctly inserted and secured to the drainage system.
What to do if the lid of Midea MLV43A3AWW is locked or will not open?
If the lid of your Midea Washer is locked or won't open, try pressing the Start/Pause button to pause the washer. If the lid is locked when the washer is not running, press the Power button to turn on the washer.
How to troubleshoot Midea MLV43A3AWW that does not start?
If your Midea Washer doesn't start, first ensure it's properly plugged in and the lid is completely closed. Then, check that the water source faucets are open and that you have pressed the Start/Pause button. Also, verify the fuse or circuit breaker.
What to do if Midea MLV43A3AWW Washer has no water or not enough water?
If your Midea Washer isn't filling with enough water, make sure both faucets are fully turned on and that the water pressure meets the requirements. Check that the water inlet hoses are not kinked, and try disconnecting the hoses to clean the screens.
What to do if Midea MLV43A3AWW stops during cycle?
If your Midea Washer stops mid-cycle, verify that the power outlet is working. Check the fuse or reset the circuit breaker. Also, ensure the lid is closed, then press the Start/Pause button. Clean the inlet hoses periodically.
How to prevent oversuds in Midea MLV43A3AWW?
To resolve an oversuds condition in your Midea Washer, use a high-efficiency detergent. If you have soft water, reduce the amount of detergent you're using.
Why is the load too wet at the end of Midea MLV43A3AWW Washer cycle?
If your laundry load is too wet after a cycle in your Midea Washer, try using a high-efficiency detergent to reduce over-sudsing. The load may also be too small.
How to prevent odor in Midea MLV43A3AWW?
To prevent odor in your Midea Washer, periodically run a Tub Clean cycle to clean the tub. Use a high-efficiency detergent to reduce over-sudsing, and dry the interior of your washer after the total cycle has finished.
To Next Page
General