Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Care
TroubleshootingWasher Use
5. Tighten the fittings by hand until they are snug, and then tighten
them an additional two-thirds of a turn with a pliers.
Caution
• Do not overtighten the fittings or apply tape or sealant to the
faucets or water supply intakes. This can damage the fittings.
• Make sure that the water supply hoses are not twisted or bent. A
bent or twisted hose can leak and cause an electric shock due to
the water leakage. To ensure the correct water usage, connect both
hot and cold water faucets. lf either or both are not connected, an
error code could occur.
6. Turn on the hot and cold water supplies and check all the water
supply intake connections and the faucets for water leaks.
Connect the drain hose
Caution
• Failure to slide the drain hose completely over the washer’s drain
pipe may result in water leakage.
• Failure to move the clamp or hoop onto the washer’s drain pipe will
result in water leakage.
1. Turn on the hot and cold water supplies and check all the water
supply intake connections and the faucets for water leaks.
21
To Next Page
Loading...
Need help?
General