Midea MLV43A3AWW User Manual

34
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Care
TroubleshootingWasher Use
Problem Solution
Washer does
not start
•
Make sure that your washer is plugged in.
•
Make sure that the lid is closed.
•
Make sure that the water source faucets are open.
•
Make sure that you press the Start Pause button to start
your washer.
•
Before your washer starts to fill, it makes a series of
clicking noises to make sure that the lid is locked. The
washer doesn't drain after the lid locks. For automatic
cycles: Before filling, and after the lid locks, a load
sensing program starts. Washer will agitate clothing
without water to determine load type, water level, and
cycle time. Then it fills. This can take up to one minute.
Its normal. For non automatic cycles the washer fills after
the lid locks.
•
Check the fuse or reset the circuit breaker.
No water or not
enough water
•
Make sure that both faucets are fully turned on.
•
Make sure that the water pressure is in the range listed in
Water requirements on page 14.
•
Make sure that the water inlet hoses are not kinked.
Straighten if necessary.
•
Disconnect the hoses and clean the screens. The hose
filter screens may be clogged.
•
This is a water eciency washer. It does not fill to the
levels of a standard washer. Low water levels are normal.
It is normal for parts of clothing to stick out of the water.
•
For automatic cycles: Before filling, and after the lid
locks, a load sensing program starts. Washer will agitate
clothing without water to determine load type, water
level, and cycle time. Then it fills. This can take up to one
minute. Its normal. For non automatic cycles the washer
fills after the lid locks.
BEFORE YOU CALL FOR SERVICE...
Troubleshooting Tips
Save time and money! Review the charts on the following pages first and you may
not need to call for service.

Midea MLV43A3AWW Specifications

General

Brand	Midea
Model	MLV43A3AWW
Category	Washer
Language	English