Error Codes
Your washer is equipped with an automatic error-monitoring system to
detect and diagnose problems.
ERROR
CODE
POSSIBLE CAUSE SOLUTIONS
Your washer takes more
than 30 minutes to fill
Washer. Or when the water
level sensor does not
detect water level change
after water is flowing for
5 min.
• Make sure that the lid is
not open.
• Make sure that water is
not leaking. See No water
or not enough water on
page 26.
The unit takes more than 10
minutes to drain.
• See Washer does not
drain on page 27.
The lid is open. Or the
washer is not level.
• Close the lid.
• Level the washer. See
“Step 4: Level your
washer” on page 19.
Your washer is out of
balance more than three
times during a spin
operation.
• See Washer vibrates or is
too noisy on page27 .
• See Washer vibrates or is
too noisy on page27 .
Notice:
1. LED display: when an error occurs, Extra Rinse LED will flash and the
wash process LEDs will indicate an error code
2. O - o,
- blink, ● - Lighting
3. When an error occurs. Please refer to troubleshooting guide or
installation instructions and try again. If error codes persist, call for
service.
37
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Care
TroubleshootingWasher Use
To Next Page
Loading...
Need help?
General