Midea MLV41N1AWWC Service Manual

Service manual for Washing Machine Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 24 －
A. Water inlet time over 60 minutes (E1)
Whether the Drain Hose is
hung up beyond the height of
100cm
The drain hose end should be over 100cm height from
the bottom of the unit.
Check the faucet for fully open.
Check the water pressure.
The water pressure should be in range from 0.05MPa to
1MPa.
Check the drainage hose.
If the unit is draining water at the same time, check the
pump for failure.
Whether the inlet filter net is
blocked
Clean the water filter if blocked.
Check the wire connection.
Check the wires for open
cycled.
If the wires are open cycled, replace the harness.
Check the inlet valve. Replace
if failure.
The resistance on coil should be between
0.7-1.2KΩ.
Check the water level sensor
Test the electric capacity between
terminal 1 and terminal 2, terminal 2
and terminal 3. If the capacity is not
in range from 40nF to 50nF, replace
the water level sensor.
1
2
3

Midea MLV41N1AWWC Specifications

General

Brand	Midea
Model	MLV41N1AWWC
Category	Washer
Language	English