MCAC-UTSM-2008-05 Optional Controller
Control 107
NOTE
● Never turn screws too tightly, or else the cover would be dented, or the Liquid Crystal breaks.
● Do not cut wires when installing Wire Controller cover.
Installation on the wall
Cut a hole that can let a Three-core Rubber Insulating Screen Cable pass by from the middle of
Wire Controller Top Cover before installation.
Refer to Electrical Switch Box Installation above for other installation information you need.
Use Clue around the Screen Cables and the Hole for sealing after installation completed.
NOTE
● Never turn screws too tightly, or else the cover would be dented or the Liquid Crystal breaks.
● Do not cut wires when installing Wire Controller Cover.
● Please leave enough long cable for maintenance of the Wire Controller Board.
To Next Page
Loading...
