Optional Controller MCAC-UTSM-2008-05
110 Control
4 CLOCK button:
Normally display the clock set currently (display 12:00 for the first electrifying or resetting). When push the
button for 4 seconds, the hour part on the clock display flashes every 0.5 seconds, then push button and to
adjust hour; push the button CLOCK again, the minute part flashes every 0.5 seconds, then push and button
to adjust minute. When set clock or alter
clock setting, must push the confirm button to complete the setting
Installation
Installation Notice:
When the air conditioner needs the constant frequency wire Controller, be sure adding a Wire Joint with 5
terminal named
A, B, C, D, E in indoor unit, and fixing a infrared emitter whose anode and cathode connecting with A and B
near the receiver
in the Indoor Unit Switch Board, then connecting the terminal +5v, GND, Run in the Switch Board to C,D,E
respectively.
To Next Page
Loading...
