Midea MPPD-12HRN1-BH9 - Dual-Hose Model Parts Identification

23
Drain pipe 30 Pipe temperature sensor assembly
24
Drain stopper 31 Indoor temperature sensor assembly
24
Drain stopper 32 Air exhaust volute shell assembly
27
Chassis assembly 32.1 Asynchronous motor
27.2
Shaded pole motor 32.2 Cover of air exhause volute shell
27.4
Spring 32.3 Connector of air exchaust duct
27.5
Water wheel 32.4 Middle partition board
27.6
Water level sensor 32.5 Centrifugal fan
27.7
Bracket of water level sensor 32.6 Power cord
27.8
Micro switch 33 Capacitor box
27.9
Bracket of Micro switch 34 Capacitor of compressor
27.10
Dobber case 35 Fasten board of Capacitor
27.11
Dobber 36 Capacitor of fan motor
27.12
Universal wheel 37 Capacitor box
27.13
Chassis 39 Outdoor air inlet grille assembly
27.16
Waterproof foam 39.1 Outdoor air inlet grille
27.17
Top cover of Shaded pole motor 39.2 filter
27.18
Bottom cover of Shaded pole motor 40 Connector, air exchaust duct
28
Compressor 41 Top filter
29
Supporting bar 42 Indoor air inlet grille
6. 2 Dual-hose model
