Midea MSAG-10CRN8 - Page 51

49
53
How to Use Advanced Functions
FP function
or
SET function
Press this button 2 times during one second under HEAT Mode and setting temperature of
16°C/60°F or 20°C/68°F(for model of RG10B10(B2)/BGEF).
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8°C/46°F.
Press this button 2 times under HEAT Mode and setting temperature of 16°C/60°F or 20°C/68°F
(for model of RG10B10(B2)/BGEF) to activate the FP function. Press On/Off, Sleep, Mode, Fan
and Temp. button while operating will cancel this function.
Note: This function is for heat pump air conditioner only.
2
SET
SET
OK
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Fresh ( ) Follow Me( ) AP mode( )
[ * ]: If your remote controller has Fresh button, you can not use the SET button to
select Fresh feature.


*
The SLEEP function is used to decrease energy while you sleep(and don’t
need the same temperature settings to stay comfortable). This function can
only by activated via remote control.
Note: The SLEEP function is not available in FAN or DRY mode.
For the details, please see “sleep operation ” in “ USER’S MANUAL ”.
SLEEP Function
Press SLEEP button