Wiring MCAC-UTSM-2008-05
96 Installation
6.2.1 Connect the cable
1. Dissemble the bolts from the cover.(If there isn't a cover on the outdoor unit, disassemble the bolts
from the maintenance board, and pull it in the direction of the arrow to remove the protection board.
2. Connect the connective cables to the terminals as identified with their respective matched numbers
on the terminal block of indoor and outdoor units.
3. Re-install the cover or the protection board.
6.2.2 The Specification of Power
Capacity 12000Btu/h (With 1-phase outdoor unit)
Phase 1-Phase
Frequency and voltage 220-240V~ 50Hz
Power wiring 3X1.5
Indoor unit power
Circuit breaker(A) 16
Indoor / Outdoor connection wiring (mm
2
) 4-Core Wire 4X1.5
To Next Page
Loading...
