Midea MWF09HB4

11
2
3
4
5
Handling the remote controller ......................................................
Remote controller Specifications...................................................
Function buttons .................. .........................................................
How to use the buttons .................................................................
Auto operation..........................................................................................................
Cooling/Heating/Health operation...........................................................................
Dehumidifying operation ........................................................................................
Swing operation.......................................................................................................
Sleep operation.......................................................................................................
Timer operation ......................................................................................................
CONTENTS
Use the remote controller within a distance of 5
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
Location of the remote controller.
5m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
Handling the remote controller
22
SleepSleep
CFhiletecrkCFhiletecrk
FoMlleow FoMlleow
AutoAuto
On/offOn/off
FanFan
HighHigh
Med Med
LowLow
ESnaevregryESnaevregry
onon
offoff
TimerTimer
AutoAuto
FanFan
CoolCool
DryDry
ModeMode
TEMP/TIMERTEMP/TIMER
TEMP/TIMERTEMP/TIMER
HeatHeat
O
N/O
F
F
M
O
D
E
5
5
6
6
7
7
TEM
P
TIMER
SWING
FAN
SLEE
P
PO
WE
R
MOD
E
The remote controller is powed by two dry batteries(R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new batteries,placing the(+) and (-) ends
correctly.
(3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all programming.
After inserting new batteries, the remote controller must be reprogrammed.
Replacing batteries