Failure to follow these instructions can result in death,
fire or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Earthing Method
A 115 Volt /60 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided. Use
receptacles which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, turn the refrigerator control to OFF
and then disconnect the refrigerator from the electrical source.
When you are finished, connect the refrigerator to the
electrical source and reset the control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation, the doors
may not close or sealed properly, causing cooling, frost, or
moisture problems. It is very important for the refrigerator to
be leveled in order to function properly.
To level your refrigerator, you may either turn the level leg
clockwise to raise that side to the refrigerator or turn counter
– clockwise to lower that side.
To Next Page
Loading...
Need help?
General
