LSB
Press FUNCTION button, the display will show “F-“ to prompt you to input a
function code. Then press button 8 (LSB), current LSB value will appear on the
display. Now, you can change LSB using numerical button or + / - button to
change it ranging from 1 to 128.
Transmitted LSB is the figure on the display minus 1. For example, “099” on the
display is transmitted as 98, etc.
About 3 seconds later after you complete the operation, the display will return to
indicate program number. Bank select is executed if Program change is done!!
MIDI MODE
Press FUNCTION button, the display will show “F-“ to prompt you to input a
function code. Then press button 9 (M.RST), current MIDI mode code will
appear on the display. Now, you can change MIDI mode by numerical
button 1 - 4 or + / - button to change it.
1: Omni On, Poly
2: Omni On, Mono
3: Omni Off, Poly
4: Omni Off, Mono
About 3 seconds after you complete the operation, the display will return to
indicate program number.
RESET ALL CONTROLLER
Press FUNCTION button, the display will show “F-“ to prompt you to input a
function code. Then press button 0 (C.RST), “ALL” will appear on the display
and message of reset all controllers will be sent out immediately.
About 3 seconds later after you complete the operation, the display will return to
indicate program number.
To Next Page
Loading...
