18
SPECIAL SETUP CONFIGURATION
3 way conversation always on While in Setup mode, press the Phone and AUX buttons for 3 sec.
Steady Blue for two seconds= activated Double long ash = deactivated
Change VOX sensitivity or disable it While in Setup mode, press short the AUX buttons (blue light on). Now, press “Volu-
me +” or “Volume -“to increase or reduce sensitivity. Press again the AUX button to
conrm the new setting and go back to the SETUP mode (Red light always on).
Blue light ashing:
Once = VOX disable
Twice = very low sensitivity
3 times = low sensitivity
4 times = medium sensitivity.
5 times = high sensitivity
Exit SETUP mode While in Setup mode, long press the Intercom button. The Red light will turn off and
the Blue light starts ashing.
FCC Compliance Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference. ›
This device must accept any interference received including interference that may cause undesired operation. ›
Warning! Changes or modications to this unit not expressly approved by Midland Radio Corporation could void the user’s
authority to operate the equipment.
To Previous Page
Loading...
