English-3
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Equipment Alert
Tighten both clamps on rubber sleeve on separator inlet
connection. Refer to Solmetex documentation (in separator
packaging) for replacement parts, cleaning and maintenance
instructions for separator.
Step 3: Install separator.
A) Assemble hose, elbow, adapter, and rubber sleeve to the separator inlet.
B) Engage slot on bottom of separator with pin on bottom bracket.
C) Push top bracket down over tabs until separator is secure.
D) Tighten top bracket bolts.
E) Remove intake hose from operatory and reconnect to tank inlet on separator.
(Use previously supplied intake hose assembly.)
For Twin set-ups go to next page for Steps G and H.
F) Connect supplied flex hose, (029-5492-00), from separator inlet to operatory.
G ) Attach collection container to separator and lock with retaining pins.
Note: The mounting plate packaged with the separator will not be used.
AA2365-1
Hose
Elbow
Adapter
Retaining
Pins
Rubber
Sleeve
Tank Inlet
Out to
Operatory
Slot and Pin
Separator
Inlet
Tabs and
Top Bracket
Seperator
Inlet
To Next Page
Loading...