Midmark PowerVac - User Manual

To Next Page

English-1

PowerVac G with Solmetex and Mounting Bracket

[002-1524-00]

PowerVac G Mounting Bracket Only

[002-1522-00]

PowerVac with Solmetex and Mounting Bracket

[002-1523-00]

PowerVac Mounting Bracket Only

[002-1521-00]

Contents:

Installation ................1 thru 3

Exploded Views ......4

Special Tools:

none

Language of origin: English

Intended Use:

To provide the PowerVac and PowerVac G with an amalgam separator.

Step 1: Install left and right bracket legs.

A) Loosen 2 screws on both sides of base unit.

B) Slide bracket legs under screw heads and tighten.

Left Leg Bracket

WARNING

Equipment is not suitable for use in the presence of a flammable anesthetic mixture.

003-2416-00 Rev. CA1 (8/25/17)

Right Leg Bracket

Note

PowerVac G is shown. PowerVac

installation is the same steps.

midmark.com

Need help?

Do you have a question about the Midmark PowerVac and is the answer not in the manual?

Midmark PowerVac Specifications

General

Brand	Midmark
Model	PowerVac
Category	Control Unit
Language	English

Summary

Installation Steps

Step 1: Install Left and Right Bracket Legs

Install left and right bracket legs by loosening base unit screws and sliding legs under screw heads.

Step 2: Install Front Plate

Secure top and bottom brackets to front plate, apply loctite to bolts, and install front plate to side brackets.

Step 3: Install Separator

Assemble separator components, attach to bracket, connect hoses, and secure collection container.

Step 3: Continued for Twin Set-up

Connect flex hose for twin set-ups from separator inlet to tee assembly and attach collection container.