MidNite Solar Classic 150

To Next Page

Directions for equalizing the solar panel using the

MIDNITE Solar Classic 150 Charge Controller

1. Check programmed absorb, equalize, and float voltages

Note: These values should already be set to the correct values

according to the manual

1. Repeat presses of the “Main Menu” until “Charge” is highlighted

2. Press “Enter”

3. Highlight “Volts”

4. Press “Enter”

5. Make sure the Equalize, Absorb, and Float voltages are 30.6 V, 29.2 V, and

27.0 V respectively.

Figure A.1: Programmed Voltage Settings

6. If the voltages do not match up, highlight the values and adjust them

accordingly using the up and down arrow keys.

7. Press “Enter” to save the values

8. Press “Status” to return to the home screen

2. Check programmed equalization time

1. Repeat presses of the “Main Menu” until “Charge” is highlighted

2. Press “Enter”

3. Scroll to the right and highlight “ChgTime”

4. Press “Enter”

Need help?

Do you have a question about the MidNite Solar Classic 150 and is the answer not in the manual?

Summary

MIDNITE Solar Classic Equalization Procedure

Check Programmed Voltages

Verify programmed Equalize, Absorb, and Float voltages match manual specifications, adjusting if necessary.

Check Programmed Equalization Time

Confirm the programmed equalization time is set to 2:00 hours as specified.

Start Manual Equalization

Initiate Equalization Process

Navigate to the 'EQ Started' option on the charge controller interface to begin the manual equalization.

Stopping Manual Equalization

Reverse steps to highlight 'EQ Stopped' to manually terminate the equalization process.

Inverter LED and Display Codes

LED and Digital Display Codes Description

Inverter Input Voltage Operating Limits

Voltage Operating Limits Table

PROwatt SW 1000 Troubleshooting Reference

Troubleshooting Conditions and Solutions

Consult the table for common error conditions (E01-E10, no output, no AC) and their corresponding possible causes and solutions.

JW-MPPT 2.0 Charge Controller User Interface

Charge Controller Interface Elements

JW-MPPT 2.0 Charge Controller Operation

LED Status Indicators