Cleaning and care
67
Cleaning the control panel
The control panel should only be
wiped with a damp cloth.
Cleaning the reflector panel
The reflector panel for the optical in-op-
eration indicator light is situated on the
cover sheeting underneath the worktop.
The reflector panel should only be
cleaned with a damp cloth if neces-
sary.
Cleaning the appliance front
Damage due to soiling.
Soiling that is left too long might be-
come impossible to remove and
could cause the external surfaces to
alter or discolour.
It is therefore best to remove any
soiling immediately.
Clean the appliance front with a clean
soft sponge and a solution of warm
water and washing-up liquid. After
cleaning, wipe the surfaces dry using
a soft cloth.
A clean, damp microfibre cloth
without detergent can also be used.
To avoid damaging the external sur-
faces, do not use the following:
– Detergents containing soda, ammo-
nia, acids or chlorides
– Detergents containing descaling
agents
– Abrasive detergents, e.g. scouring
powder, scouring liquid, or pumice
stones
– Detergents containing solvents
– Stainless steel cleaning agents
– Dishwasher cleaner
– Oven cleaner
– Glass cleaning agents
– Hard, abrasive brushes or sponges,
e.g. pot scourers, brushes or
sponges that have been previously
used with abrasive cleaning agents
– Eraser stain remover blocks
– Sharp metal scrapers
– Wire wool
– Steam cleaners
To Next Page
Loading...
