Miele 11070970 - Page 83

Problem solving guide
83
Problem Cause and remedy
The optical in-operation
indicator light is flash-
ing quickly.
At the end of the pro-
gramme, the alarm tone
sounds and the display
shows the following
message:
Fault F601
There is a fault in the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see the “De-
tergent” chapter, “Automatic dispensing/AutoDos”
section).
 Activate the AutoDosfunction and start the pro-
gramme again.
If the fault message appears again, there is a tech-
nical fault. You can continue to use your dishwasher
by deactivating automatic dispensing using the
AutoDossensor control and manually dispensing
the detergent via the detergent compartment.
 If you wish to use automatic dispensing again,
contact the Miele Customer Service Department.
The optical in-operation
indicator light is flash-
ing quickly.
At the end of the pro-
gramme, the alarm tone
sounds and the display
shows the following
message:
Problem with AutoDos
The dishwasher does
not switch off at the end
of the programme.
The wash items may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The AutoDosfunc-
tion is automatically de-
activated during the
programme sequence.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDosfunction was automatically deactiv-
ated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the pouring channel of the AutoDos (see
“Detergent” chapter, “Cleaning the AutoDos” sec-
tion).
 Clean the lower spray arm (see “Cleaning and
care” chapter, “Cleaning the spray arms” section).
 Select OK to confirm each message.
 Activate the AutoDosfunction by confirming the
messageAutoDos available using OK.
 Start the programme again.
The programme duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.